Xiaomi Mi CC9e Xiaomi Mi CC9e

Xiaomi Mi CC9e Firmware Flash File Download [Stock Rom]

Looking to install the stock ROM on your Xiaomi Mi CC9e? This comprehensive guide provides direct download links for the firmware flash file and clear, step-by-step instructions to get your phone back on track.

Use this firmware file to effectively reset your phone, fix bootloop issues, bypass password locks, resolve device freezing, and address numerous other software problems.

This file is strictly for the Xiaomi Mi CC9e.

Download:

RegionFastboot Download Links
China
EU

The Requirements

Flash the Xiaomi Mi CC9e Firmware Using Xiaomi MI Flash Tool

  1. Download on your PC the firmware file that you wish to flash to your phone, and extract the file to get the flash files inside.
  2. Now, download the Xiaomi USB driver, extract the driver, and install it on your PC.
  3. Download the Xiaomi Flash Tool to your PC, and extract the zip file to get the files below.
  4. Locate the folder, find XiaoMiFlash.exe, and launch it as an administrator.
  5. A pop-up will appear asking you to install some drivers; click on “Install” to install the drivers.install-drivers-xiaomi-flashtool
  6. After the driver installation, ready your phone by booting your phone to “download mode.”
  7. If you face any issue with the above setup, download the installer version that installs on your PC instead.
  8. To boot your Xiaomi phone to “Download Mode,” first power it off, and while off, press and hold the volume down + power button for a few seconds till “Download Mode” appears.
  9. On the tool, click “select” to locate the firmware you recently extracted.
  10. You need to select the “firmware” folder where all the files are located (not the file).
  11. Next is to connect your phone to the PC using the USB cable, and you will see that the tool has detected your phone.
  12. Drop your phone and ensure not to interrupt it during flashing.
  13. For those with an open bootloader, remember to click this at the bottom of the tool to avoid locking it back.clean-all-xiaomi-tool
  14. Click on “flash” to begin the flashing process; the tool will take a few minutes to complete flashing.xiaomi-mi-flash-tool-start-flash
  15. Once the flashing is done, unplug your phone, close the Xiaomi MI Flash Tool, and enjoy the new experience.

Leave a Reply

Your email address will not be published. Required fields are marked *