Crucial Warning: Always select 'Download Only' in SP Flash Tool. Never choose 'Format All + Download'. Full formatting will erase the NVRAM partition, which permanently removes your IMEI numbers and cellular network reception.
Download Firmware for Lenovo Vibe C2
K10a40 (Global / Official) Final official maintenance release (S230) for the Lenovo Vibe C2 (K10a40). Recommended for fixing boot loops and returning the phone to factory condition.
Not sure this is the right one for you? The full list below covers every build.
Compatibility & Bootloader Notes
Flashing stock firmware through SP Flash Tool communicates directly with the MediaTek Preloader interface and does not require an unlocked bootloader.
Preparation checklist for Lenovo Vibe C2
- Check the sticker under the battery to confirm the model number is K10a40.
- Install MediaTek USB VCOM drivers on your Windows PC.
- Extract the firmware archive to locate MT6735_Android_scatter.txt.
- Ensure the battery has at least 40% charge before you begin.
- Back up any accessible personal files before flashing.
Flashing Instructions
Step-by-step flashing instructions for Lenovo Vibe C2 are on FlashGuideHub's SP Flash Tool guide.
Frequently Asked Questions
To keep your IMEI safe, never use "Format All + Download" in SP Flash Tool. Always select "Download Only". "Download Only" writes firmware images to system partitions while leaving your NVRAM and radio calibration data intact.
Take the removable battery out for 5 seconds, put it back in, hold the Volume Down button, and plug the USB cable into a rear USB port on your PC.
The standard Lenovo C2 (K10a40) has a 2750mAh battery and 1GB RAM, while the C2 Power has a 3500mAh battery and 2GB RAM. Check the model code under the battery. If your device is a standard K10a40, this package is fully compatible.