Leagoo Leapad 10S Firmware Flash File Download [Stock Rom]

The Leagoo Leapad 10S was a 10.1-inch budget tablet designed around media consumption and long battery life, featuring a massive 5500mAh battery. However, this was paired with extremely limited hardware: a MediaTek MT6737M processor, just 1GB of RAM, and 16GB of storage. While the tablet runs a relatively modern version of Android 8.1 Oreo, the low-end hardware struggles significantly, leading to extreme performance lag, app crashes, and poor battery optimization that undermines its main selling point. For owners of this tablet, reinstalling the official stock firmware is the only effective way to perform a clean factory reset and restore a baseline level of usability.

This guide provides the official stock ROM package for the Leagoo Leapad 10S, allowing you to perform a complete software reinstallation.

Leagoo Leapad 10S Firmware Details

Below are the key specifications for the Leagoo Leapad 10S. This firmware will restore the device to its original Android 8.1 Oreo software.

Why Flash the Stock Firmware on Your Leagoo Leapad 10S?

Flashing the stock firmware is essential for addressing the critical performance issues caused by the tablet’s underpowered hardware:

• Fix Extreme Performance Lag: This is the primary reason to flash. A clean OS install is the only way to temporarily address the severe system-wide lag caused by the MT6737M processor and 1GB of RAM struggling to run Android 8.1 on an HD display.
• Resolve Abnormal Battery Drain: A fresh OS can fix software bugs and remove rogue processes that cause the huge 5500mAh battery to drain much faster than it should, restoring its key feature.
• Resolve “Insufficient Storage” Errors: Wipes the device clean, freeing up the limited 16GB of internal storage to allow essential system functions and a few apps to run.
• Stop Constant App Crashes: Solves persistent “force close” errors caused by the device running out of memory.

⚠️ Important Prerequisites

Before you begin, back up any accessible data. This process will completely erase all data from the tablet’s internal storage.

• The latest version of the SP Flash Tool.
• The correct MediaTek VCOM USB drivers installed on your PC.

Download Official Firmware for Leagoo Leapad 10S

• Build Date: 20200111
  • File Name: Leagoo_Leapad_10S_MT6737M_v1.1G_1_16_v1.5_20200111.zip
  • Size: 953 MB
  • 🔗 Download Link: Download (Google Drive)

How to Flash the Firmware

This firmware must be installed using the SP Flash Tool. The process involves loading a scatter file from the downloaded firmware. Here is a summary of the steps:

1. Download and extract the Leagoo_Leapad_10S_..._20200111.zip file to a new folder on your computer.
2. Ensure the MediaTek VCOM USB drivers are properly installed on your PC.
3. Launch the SP Flash Tool software.
4. Click the “Scatter-loading” button and select the MT6737M_Android_scatter.txt file from the extracted firmware folder.
5. Completely power off your Leagoo Leapad 10S.
6. In SP Flash Tool, confirm the mode is set to “Download Only,” then click the green “Download” button.
7. Connect your powered-off tablet to the computer via USB cable to begin the flashing process.

For a complete, step-by-step tutorial with screenshots and troubleshooting, please follow our master guide:

→ How to Flash Stock Firmware to MediaTek (MTK) Smartphones

Disclaimer: Flashing firmware is an advanced procedure that carries inherent risks. If instructions are not followed precisely, you could permanently damage your device. We are not responsible for any data loss or hardware issues. Proceed with caution.